problem with AX1500 RC third channel not controlling the C output

14 years 8 months ago #29524881 by hemantdandekar
I am using the AX1500 motor controller and trying to use third channel in RC mode. Channel 1 and 2 are some time working file but suddenly motors out of control again i want to control the Relay using third channel on output C (pin 1 and 9)i am not getting ant signal on it. This C output is working fine in RS232 mode with command !c and !C.
Please give me the solution.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.064 seconds