Why does my SDC2150 show up in roborun as SDC2130?

Hi, I actually bought 2 controllers, both are SDC2150. However, the other controller i got seems to show up in roborun as SCD2130 even though it is labeled as an SDC2150 (SN R0210) in the controller. I tried to run it with a 48v supply and the controller signaled out an overvoltage status. I tried to run the controller with different firmware such as the single channel version however it just showed up as SDC2130s. Is this a problem with the firmware or the roborun? or did i receive the wrong controller?

btw the other controller works fine. roborun detects it as SDC2150

Check that the jumper is present on the header of the board that reports itself as SDC2130.

The SDC2150 has higher voltage components but since it uses the same firmware, the presence or absence of jumper is what changes the id and the overvoltage value.