1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. Making AX500SC double channel

Making AX500SC double channel

13 years 4 months ago #29526570 by Anonymous
Making AX500SC double channel was created by Anonymous
We purchased your AX500SC model driver card. We would like to make this into a two channel card. According to your manual all I would have to do is remove the solder ball jumper. Is this all that needs to be done?

Please Log in or Create an account to join the conversation.

13 years 4 months ago #29526571 by Roboteq
Replied by Roboteq on topic RE: Making AX500SC double channel
Yes. then make absolutely sure that you don't have the two motors output channels wired to each other.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. Making AX500SC double channel
Time to create page: 0.069 seconds