Connecting RC servo on AX3500
- Anonymous
- Topic Author
14 years 3 weeks ago #29526578
by Anonymous
Connecting RC servo on AX3500 was created by Anonymous
I purchased the AX3500 and would like to take advantage of Channel 3 on the RC connection cable. Where on the AX3500 do I connect a standard RC servo that will respond to channel 3 on my radio? Is it in one of the 8 RC outputs on the board?
Please Log in or Create an account to join the conversation.
- Roboteq
- Topic Author
14 years 3 weeks ago #29526579
by Roboteq
Replied by Roboteq on topic RE: Connecting RC servo on AX3500
The 3rd channel is for activating the Output C of the controller.
If you want to drive a servo, then you should contact the servo directly to the radio.
If you want to drive a servo, then you should contact the servo directly to the radio.
Please Log in or Create an account to join the conversation.
- Anonymous
- Topic Author
14 years 3 weeks ago #29526580
by Anonymous
Replied by Anonymous on topic RE: Connecting RC servo on AX3500
Where is output C on the controller? I can't locate it.
Please Log in or Create an account to join the conversation.
- Roboteq
- Topic Author
14 years 3 weeks ago #29526581
by Roboteq
Replied by Roboteq on topic RE: Connecting RC servo on AX3500
It is on the 15-pin connector. Pin 1-9. See manual (please retrieve from www.roboteq.com)
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.062 seconds