1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. Using 28V battery for AX500

Using 28V battery for AX500

12 years 5 months ago #29526698 by Anonymous
Using 28V battery for AX500 was created by Anonymous
My battery voltage exceeds 28v in full charge condition. Is it a problem for Ax500?

Please Log in or Create an account to join the conversation.

12 years 5 months ago #29526699 by Roboteq
Replied by Roboteq on topic RE: Using 28V battery for AX500
Max voltage for the AX500 is 24 Volt. There is some margin, and you may want to try the 28 Volt if this is a hobby application but please note the following:
Make sure you do not use 28 Volt for the Vcom auxiliary supply. Use one battery only voltage for Vcon (14 Volt); Vcon only takes about 50 milliamp.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. Using 28V battery for AX500
Time to create page: 0.053 seconds