1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. Basic question about encoders

Basic question about encoders

9 years 7 months ago #29528317 by infoa
Basic question about encoders was created by infoa
Hi,

I have a doubt about encoder. The connection for the supply is 14 DB15 Pin, 5V out. OK.
But, What GND point for encoder use?
1. - DB15 Pin 5
2. - Or DB15 Pin 13
3. - Or GND point of general power supply pins(12V/GND)

Thanks,

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. Basic question about encoders
Time to create page: 0.049 seconds