Pinout Button not Highlighted

I received my two ldc2230c controllers today. I hooked one up and everything seems to work with the two channels and so on.
Issues/Questions

-The one problem that I'm having is that the pinout button is not highlighted.
-Also if I want to connect both a RC input and serial input. Do I have to connect these connections on a breadboard with parallel connections?

Thanks ( in advance).

The pinouts are located in the datasheet. The pinouts button is available when the controller is either connected to pc and powered on, or you set the browser in offline mode with a controller selected. This is located on the upper right of the Roborun+ browser.

If you want to wire up a RC along with the Serial, you can use the RC2 connector and wire up the Tx, Rx, and GND connections on the RC2 along with the pulse inputs. Refer to the datasheet for wiring pinouts.

ok, the controller was connected and the "pinout" button is still not highlighted.
Also, I selected the "offline" and selected the controller and still no highlighted "pinout" button.
any ideas?

Please see attached screenshots for my previous post. with controlled powered-up (see roboteq1.jpg)
for offline mode, see attached (roboteq2.jpg)

Does anyone have any ideas?

Sorry, I've been tied up this morning. It looks like the XML tree for the LDC2230 will need to be updated. In the offline mode, this is not a functional feature.

As stated otherwise, the datasheet for this product has the pinout.

How does that get updated?

This is something we have to fix. Right now I can't provide an ETA of when since I don't handle this directly. Once we get the fix we can upload this file her for you to download.

I have the same problem with the driver SBL1360
There is a solution to the problem?

Regards

I used a certain ttl-serial converter and the proper syntax for the serial commands.