1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. CAN Connection

CAN Connection

9 years 2 months ago #29529073 by Beginner
CAN Connection was created by Beginner
Hi,

I connect HDC2450 to my pc via PCAN/USB for CAN connection. But software Roborun+ doesn't find HDC2450. If I connect HDC2450 via USB, Roborun+ finds it.

Could you hep me .

Thanks

Please Log in or Create an account to join the conversation.

9 years 2 months ago #29529074 by Griffin Baker
Replied by Griffin Baker on topic CAN Connection
The pcan is for can bus activity. Therefore it is not connected on the serial lines of the controller to communicate to the Roborun+ software. You'll either have to use the usb, or connect via serial (2,3,5 of the DB25 pin I/O) to communicate with the roborun.

Please Log in or Create an account to join the conversation.

9 years 2 months ago #29529075 by Beginner
Replied by Beginner on topic CAN Connection
but I have to use DB9 to send and receive CAN frames for labVIEW.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. CAN Connection
Time to create page: 0.080 seconds