CAN Connection for HDC2450 and HBL1650

9 years 3 months ago - 9 years 3 months ago #29529353 by Beginner
Hi,

If I connect my devices HDC2450 and HBL1650 on CAN bus electrical, how do I distinguish my devices on CAN bus. There is only eds file for these devices. For example : I set PWM at 200 for HDC2450, I must set this value in object 2000 (Cmd_CANGO). Then, this value is used too by HBL1650. because, it has the same object 2000 (Cmd_CANGO)

Best regards

Please Log in or Create an account to join the conversation.

9 years 3 months ago #29529354 by roboteq
Replied by roboteq on topic CAN Connection for HDC2450 and HBL1650
You need to set a different node address for each. Then the same object can be used but it will be sent to one or the other node.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.050 seconds