MDC2230 Dynamic Braking

5 years 10 months ago #29529739 by FJankun
In which mode is it possible to activate Dynamic Braking (both low side MOS active, both motor wires shorted to ground) ?

Please Log in or Create an account to join the conversation.

5 years 10 months ago #29529742 by TechSupport
Replied by TechSupport on topic MDC2230 Dynamic Braking
Open loop. The dead mans switch, and safety stop provide this by sending a motor command of 0. In the closed loop modes, sending this command may not work very efficiently and may cause problems because it depends on how well your configuration parameters are set and the PID.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.072 seconds