- Forum
- Roboteq Motor Controllers
- Controller Configuration & Operation
- mcd2230 does not responde after firmware update
mcd2230 does not responde after firmware update
8 years 4 weeks ago #29530579
by sebastian
mcd2230 does not responde after firmware update was created by sebastian
the MCD2230 does not responde to any communication after firmware was updated over dfu
the red status led stays on and the usb led stays off and the rs232 communication only shows: 'starting...'
and new firmware cannot be reuploaded through rs232 it give the fault message ;
'checking firmware... error.
new firmware message not detected''
it also cannot connect to dfu mode
what to do?
the red status led stays on and the usb led stays off and the rs232 communication only shows: 'starting...'
and new firmware cannot be reuploaded through rs232 it give the fault message ;
'checking firmware... error.
new firmware message not detected''
it also cannot connect to dfu mode
what to do?
Please Log in or Create an account to join the conversation.
8 years 4 weeks ago #29530585
by TechSupport
Replied by TechSupport on topic mcd2230 does not responde after firmware update
Please check the bottom of controller to see if the sticker says pcb rev 3.2 If so, it should have already come to you in the latest firmware.
The firmware on the web is for the 2.1. You'll need to reflash via comport at this point.
dev.roboteq.com/dev1/index.php/support/s...update-or-in-general
The firmware on the web is for the 2.1. You'll need to reflash via comport at this point.
dev.roboteq.com/dev1/index.php/support/s...update-or-in-general
The following user(s) said Thank You: sebastian
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
- Forum
- Roboteq Motor Controllers
- Controller Configuration & Operation
- mcd2230 does not responde after firmware update
Time to create page: 0.073 seconds
