Add ECHOF to profile
8 years 3 months ago #29530708
by Herman
Add ECHOF to profile was created by Herman
Is it possible to add ECHOF (Enable/Disable Serial Echo) to the profile ?
It will help me restoring profiles on multiple controllers more efficient.
Thks, Herman
It will help me restoring profiles on multiple controllers more efficient.
Thks, Herman
Please Log in or Create an account to join the conversation.
8 years 3 months ago #29530711
by TechSupport
Replied by TechSupport on topic Add ECHOF to profile
The Echo is enabled by default and can be seen in console tab. If you are doing configurations changes from the configurations tab, it will echo all commands used to make changes after you save to controller. You go directly to console tab after saving the changes.
Please Log in or Create an account to join the conversation.
8 years 3 months ago - 8 years 3 months ago #29530718
by Herman
Replied by Herman on topic Add ECHOF to profile
I am sorry, or I did not understand your answer or my question is not clear:
Lets give anaother try:
I send ^ECHOF 1 to the controller and save the configuration to EEPROM (EESAV)
I load the configuration from the controller in the configuration tab
I save the profile to disk
Question: Is the ^ECHOF 1 setting saved in the profile on disk ?
Lets give anaother try:
I send ^ECHOF 1 to the controller and save the configuration to EEPROM (EESAV)
I load the configuration from the controller in the configuration tab
I save the profile to disk
Question: Is the ^ECHOF 1 setting saved in the profile on disk ?
Please Log in or Create an account to join the conversation.
8 years 3 months ago #29530719
by TechSupport
Replied by TechSupport on topic Add ECHOF to profile
The EchoF is not a function set in the configuration. It is a serial command you can send and save.
Page 198 in the user manual.
ECHOF - Enable/Disable Serial Echo
This command is used to disable/enable the echo on the serial port. By default, the controller
will echo everything that enters the serial communication port. By setting ECHOF to 1,
commands are no longer being echoed. The controller will only reply to queries and the
acknowledgements to commands can be seen.
Syntax: ^ECHOF nn
~ECHOF
Where: nn = 0 : echo is enabled
1 : echo is disabled
Default Value: 0 = enabled
Examples: ~ECHOF 1 = Disable echo
Page 198 in the user manual.
ECHOF - Enable/Disable Serial Echo
This command is used to disable/enable the echo on the serial port. By default, the controller
will echo everything that enters the serial communication port. By setting ECHOF to 1,
commands are no longer being echoed. The controller will only reply to queries and the
acknowledgements to commands can be seen.
Syntax: ^ECHOF nn
~ECHOF
Where: nn = 0 : echo is enabled
1 : echo is disabled
Default Value: 0 = enabled
Examples: ~ECHOF 1 = Disable echo
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.058 seconds
