- Forum
- Roboteq Motor Controllers
- Controller Configuration & Operation
- Reading real-time amps with digital amp meter
Reading real-time amps with digital amp meter
7 years 5 months ago - 7 years 5 months ago #29531500
by gg
Reading real-time amps with digital amp meter was created by gg
What is common way to read real-time amps with a digital ammeter(other than using an external hall sensor on phase or batt wires)? Need to read the amps in real time.
When I have my laptop connected to the controller, I can read Battery Amps in real time as the load varies, etc. What's a good way to do this without the laptop and using a digital (or analog) amp meter? Or maybe use some other stand-alone, non-PC "reader"?
When I have my laptop connected to the controller, I can read Battery Amps in real time as the load varies, etc. What's a good way to do this without the laptop and using a digital (or analog) amp meter? Or maybe use some other stand-alone, non-PC "reader"?
Please Log in or Create an account to join the conversation.
7 years 5 months ago #29531503
by niko
Replied by niko on topic Reading real-time amps with digital amp meter
Concerning the amps reading from the Roboteq controller, this data can be extracted using either one of the CAN protocols or via USB or via serial.
If you have an extra device with a display (where you want the amps to be displayed) make sure you can connect it with the Roboteq controller with the above mentioned methods.
If you have an extra device with a display (where you want the amps to be displayed) make sure you can connect it with the Roboteq controller with the above mentioned methods.
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
- Forum
- Roboteq Motor Controllers
- Controller Configuration & Operation
- Reading real-time amps with digital amp meter
Time to create page: 0.061 seconds
