- Forum
- Roboteq Motor Controllers
- Controller Configuration & Operation
- Brushless Motor Set up in Sinusoidal Mode with FBL2360S and Incremental Encoder
Brushless Motor Set up in Sinusoidal Mode with FBL2360S and Incremental Encoder
6 years 10 months ago - 6 years 10 months ago #29532554
by Martin123
Brushless Motor Set up in Sinusoidal Mode with FBL2360S and Incremental Encoder was created by Martin123
Hi,
We have a FBL2360S v2.2A
Trying to get a brushless motor working with the above controller and an incremental encoder.
When I save the configuration as SINUSOIDAL to the controller, I am not able establish connection again with the controller via VMOT( I keep getting "Contoller has been lost" message). Only when powered via the Pwr Ctrl am able to establish connection with the controller. After I reset to factory defaults am able to establish connection via VMOT.
Also I do not have pole pairs information on the motor I have. Will it be possible to get the motor running without this info?
Appreciate any help with this!
Thanks.
We have a FBL2360S v2.2A
Trying to get a brushless motor working with the above controller and an incremental encoder.
When I save the configuration as SINUSOIDAL to the controller, I am not able establish connection again with the controller via VMOT( I keep getting "Contoller has been lost" message). Only when powered via the Pwr Ctrl am able to establish connection with the controller. After I reset to factory defaults am able to establish connection via VMOT.
Also I do not have pole pairs information on the motor I have. Will it be possible to get the motor running without this info?
Appreciate any help with this!
Thanks.
Please Log in or Create an account to join the conversation.
6 years 10 months ago #29532555
by blake
Replied by blake on topic Brushless Motor Set up in Sinusoidal Mode with FBL2360S and Incremental Encoder
Which version of firmware is on your controller? You can find this by sending ?FID from the console.
You will need to know the number of pole pairs for sinusoidal commutation. There are a few ways to find the number of poles that are in your controller, see page 92 of the user manual.
You will need to know the number of pole pairs for sinusoidal commutation. There are a few ways to find the number of poles that are in your controller, see page 92 of the user manual.
Please Log in or Create an account to join the conversation.
6 years 10 months ago #29532556
by Martin123
Replied by Martin123 on topic Brushless Motor Set up in Sinusoidal Mode with FBL2360S and Incremental Encoder
?FID
FID=Roboteq v1.6 FBL2XXX 04/14/2016
FID=Roboteq v1.6 FBL2XXX 04/14/2016
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
- Forum
- Roboteq Motor Controllers
- Controller Configuration & Operation
- Brushless Motor Set up in Sinusoidal Mode with FBL2360S and Incremental Encoder
Time to create page: 0.057 seconds
