Turn off the controller by the software not only the power stage

3 years 4 months ago #29532841 by isma
Hello everyone,

I have read in the userman that it is possible to cut off only the power stage (not the entire controller) thanks to undervoltage protection.
Is it possible to turn off also the controller by the same process ? I did not find the information in the manual.

Thanks in advance.

Isma

Please Log in or Create an account to join the conversation.

3 years 4 months ago #29532842 by blake
Hello Isma,

Do you mean turn off the controller completely?

Please Log in or Create an account to join the conversation.

3 years 4 months ago #29532846 by isma
Yes is that I mean.

Thanks for your reply.

Isma

Please Log in or Create an account to join the conversation.

3 years 4 months ago #29532849 by blake
No it is not possible to completely turn off the motor controller using just the motor controller software. You will need a relay or switch to do this which can be controlled by an external microcontroller if you wish. If you close the PwrCtrl to GND then this will completely turn off the controller.

Please Log in or Create an account to join the conversation.

3 years 4 months ago #29532855 by isma
OK. thanks for the information.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.135 seconds