1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. Analog input value displayed in Roborun+ is different than the measured value

Analog input value displayed in Roborun+ is different than the measured value

5 years 10 months ago #29533036 by isma
Analog input value displayed in Roborun+ is different than the measured value was created by isma
Hello everyone,

I have a SDC2130S linked with a pot to an Analog input.
I have an issue with the analog input displayed in Roborun+ software. Indeed, the value displayed is between 0-4V whereas I measure electrically a value between 0-5V.
I noticed there is an offset between the value I measured and the value displayed of -1V that I cannot explain…
I guess it is a configuration issue.. Do you have any idea ?

Thanks in advance.
Isma
Attachments:

Please Log in or Create an account to join the conversation.

5 years 10 months ago #29533037 by blake
Replied by blake on topic Analog input value displayed in Roborun+ is different than the measured value
This sounds like a calibration issue. Please download and install TeamViewer and then contact me at This email address is being protected from spambots. You need JavaScript enabled to view it. so that we can organize a time for me to take a look at this remotely

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. Analog input value displayed in Roborun+ is different than the measured value
Time to create page: 0.058 seconds