1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. FBL2360 FW: v.1.8b FBL2XXX : Amps Limit and Read Amps are the measured Amps/20

FBL2360 FW: v.1.8b FBL2XXX : Amps Limit and Read Amps are the measured Amps/20

5 years 3 months ago #29533341 by TeddyTheBear
FBL2360 FW: v.1.8b FBL2XXX : Amps Limit and Read Amps are the measured Amps/20 was created by TeddyTheBear
I am developing a E-vehicle with FBL2360 FW: v.1.8b FBL2XXX. My motor are 1000W 48V BLDEC motors. However, I felt that the motor delivered too less power than I expected. Then, I found that the actual amps is just around 1/10 from the configuration and also the read value from FBL2360.

I tried to configure the Amps Limit to be 20 times of the normal one. But its limit is 60 A. (But actual output power is less than 3 A).

I think the problem might be in firmware. Please give me any advice to fix this issue. Thank you very much.

Please Log in or Create an account to join the conversation.

5 years 3 months ago #29533354 by blake
Replied by blake on topic FBL2360 FW: v.1.8b FBL2XXX : Amps Limit and Read Amps are the measured Amps/20
Hello please send us your motor controller's configuration file. Also please record and save a log of the following data points (on the relevant motor channel). You can send this info to This email address is being protected from spambots. You need JavaScript enabled to view it.

Attachments:

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. FBL2360 FW: v.1.8b FBL2XXX : Amps Limit and Read Amps are the measured Amps/20
Time to create page: 0.073 seconds