RGBL1860: Sensorless calibration - issue

Dear,

After reading several posts on the forum and reading the user manual I'm still struggling configuring a RGBL1860 in sensorless mode.
I have a 3-phase BLDC motor connected to the controller (which operates at +- 50V - max 15kW).
So far I managed to get the motor turning in sensorless mode, I have followed the calibration steps. Unfortunately the motor turns extremely slow. I can reach about 10 rpm - while it should turn at arround 6000 rpm.

Anyone who can assist me? The controller has the latest firmware version installed:Roboteq v1.8d RGBL1XXX 1/8/2018
Configuration file attached.

With best regards,
MM

We are currently working on a version of firmware what automatically calibrates sensorless operation. We are hoping to release it in June.

Go ahead and email This email address is being protected from spambots. You need JavaScript enabled to view it., and we can help you install a beta version.

E-mail has been sent, thanks in advance.