Firmware update SDC2130S

Hello to all the users.
I tried to update firmware the SDC2130S driver but the update was interrupted (Roboteq Motor Control Utility).
Now it does not recognize the driver in any way, neither by USB port nor by RS232 port.
I want to know if there is any way to update the firmware using a bin or hex file.
I hope to have help.
Thanks you very much.
Regards.

Are you sure you can't force an update from an RS232 cable?

I try to do the update by RS232 but it does not detect the device.
This is the message of the Roboteq Motor Control Utility
"""Controller found on COM3.
Resetting the controller...done.
Waiting for device restart...error.
Device starting string not detected."""

There is some way to upgrade without the Roboteq Motor Control Utility software?
Thanks you very much.
Regards.

When the utilllity waits for the device restart, go ahead and power cycle the controller.

I've done that test several times but the update never starts.
Does not detect the device.

Hmm, there is a chance that the bootloader was corrupted during the failed firmware update. Go ahead and email This email address is being protected from spambots. You need JavaScript enabled to view it. and I will get you set up with an RMA tomorrow.

Gabriel,

You might want to ask Blake whether it wouldn't be cheaper or more convenient for robertito_c_r to buy an ST-LINK ISP and re-burn the bootloader himself rather than shipping the controller back and forth. Remind Blake that if the SDC is like the HDC for this, you have to make a simple adapter to go from the JTAG soccet on the ST-LINK to the controller's MCU board.

Ciao,
Lenny

Hi.
I have a ST-LINK ISP.
Can you send me the bootloader or the download link?
Thanks

The only option for fixing MCU memory corruption of this nature is through our RMA process. We apologize for any inconvenience.