1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. LDC1450 V1.1 firmware

LDC1450 V1.1 firmware

2 years 10 months ago #29535062 by hamselvdk
LDC1450 V1.1 firmware was created by hamselvdk
Hi

I accidentally loaded v.2.0 firmware onto an LDC1450 V1.1 - now the status
LED blinks as if there’s a short circuit. - Are there a way to load
1.8d on to the controller? Eg. Putting the controller into firmware
acceptance mode again? 

/Per Christiansen
This is a re-post from Software forum

Please Log in or Create an account to join the conversation.

2 years 10 months ago #29535083 by hamselvdk
Replied by hamselvdk on topic LDC1450 V1.1 firmware
Any inputs to this would be greatly appreciated!

Please Log in or Create an account to join the conversation.

2 years 9 months ago #29535105 by hamselvdk
Replied by hamselvdk on topic LDC1450 V1.1 firmware
Anyone have an idea? Is it possible to recover from this on the LDC1450?

Please Log in or Create an account to join the conversation.

2 years 6 months ago - 2 years 6 months ago #29535251 by hamselvdk
Replied by hamselvdk on topic LDC1450 V1.1 firmware
Unbelieveable that noone from Roboteq/Nidec had time to look at this and answer this question yet .. Ive even send an email with the question and got no reply.
Anyone else have an idea?

When I connect with RS232 I just get "Starting" rolling down the screen..
Attachments:

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. LDC1450 V1.1 firmware
Time to create page: 0.061 seconds