SBL2360T and BLDC motor connection

In the case of a motor, there is a U+- V+- W+- A+- B+- Z+- line, but in the case of a controller, only UVW ABC exists. So, can we connect U+- to U and V to V+-?

This is the motor data sheet.

I want to drive the motor, but it does not work. Please give me a solution

Hi Leeseho;
I'm far from an expert, but the motor data sheet says "Build-in encoder pulse: 2500" which sounds like a rotary encoder, certainly not Hall sensors, the connections for which are depicted in your first picture. Have you looked at the connection information in the "Commands and I/O Connections" section and Table 4, which contains the connections for Pulse encoders? That has 8 connections, which match the motor data sheet (8 data connections + power & ground)
Hope that helps,
pdp