Re: RC Controller Configuration (SBL2360T)

2 years 6 months ago - 2 years 6 months ago #29535389 by dayorbittech
I am unsure how to configure Din pins for RC controller. After connecting the RC controller as specified on page 55 of the manual blow, using  throttle and steering of my RC controller generates no action.

Roboteq Manual:

RC Controller Manual

I have dont he mix mode setup (page 23) to control two motors

In Utility configuration => Inputs/Outputs => Digital Inputs => Ain1(CH1), Ain2(CH2), Din3(CH3), and D4(CH4) (select "Run Script" or somehting else?)

Question 2:
In my case channel 1 to 4 LED are blinking in Run tab. Is this normal? I turned off the joystick and it still blinks. If no, whats the problem? Inteference?

Question 3:
What is the normal reaction after connecting RC Controller to the driver? (In my case nothing happened)

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.054 seconds