Dear All,
when powering up the controller (SBL1360A) in the one-battery configuration, the status LED starts blinking. We are unclear as to the meaning of this since the datasheet is not quite clear when describing the blinking patterns. It says "The Status LED will be flashing at a two seconds interval.", but this can also be interpreted as the warning signal for a detected short. When we connect the controller to the PC utility, it shows no errors. Taking into account all this information, we are quite certain that this is normal, but a quick confirmation from the technical support would go a long way. Attached is a recording of the blinking pattern.
Thanks in advance.
