FBLG Controller won't stop with NMT Stop Command

10 months 4 hours ago #29536307 by Buddy Curtis
I am using Roborun+ over USB and have CANOPEN enabled.  I have a PEAK CAN-USB device and I can succesfully put the Controller into Operational mode and set an RPM using RoboRun+ and send a NMT Reset Command. But the NMT Stop or Pre-Op commands doesn't seem to stop the motor.  Any clues?

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.068 seconds