- Forum
- RIO I/O Expansion Card and Navigation Computer
- I/O Connection and Processing
- Encoder i/o setup
Encoder i/o setup
9 years 4 months ago #29529200
by QuiXXotic
Encoder i/o setup was created by QuiXXotic
Im having trouble setting upp the inputs for my Incremental encoder on the first two analog inputs. Using analog raw in input mapping and absolute in analog inputs gives me low value 0 and high value 5000 during calibration.
But swapping to pulse raw in input mapping and trying different operation modes in Pulse i/o gives no response in calibration of the pulse.
Is it possible to get any guidance in this matter?
But swapping to pulse raw in input mapping and trying different operation modes in Pulse i/o gives no response in calibration of the pulse.
Is it possible to get any guidance in this matter?
Please Log in or Create an account to join the conversation.
9 years 1 week ago #29529735
by QuiXXotic
Replied by QuiXXotic on topic Encoder i/o setup
Anyone knows if encoder input even work yet?
Please Log in or Create an account to join the conversation.
9 years 2 days ago #29529743
by TechSupport
Replied by TechSupport on topic Encoder i/o setup
I've forwarded your question to our team.
Please Log in or Create an account to join the conversation.
9 years 2 days ago #29529744
by TechSupport
Replied by TechSupport on topic Encoder i/o setup
We are reorganizing our development and support for RIO and that we expect to be able to address all pending firmware questions within the next 30 days.
We appreciate your patience.
We appreciate your patience.
Please Log in or Create an account to join the conversation.
- Forum
- RIO I/O Expansion Card and Navigation Computer
- I/O Connection and Processing
- Encoder i/o setup
Time to create page: 0.059 seconds