rawCAN is not working on RIOX

6 years 1 month ago #29533129 by yoo0911
Hi everyone,

I need your help.
I have RIOX and PEAK can usb adapter and connected PEAK-usb to the RIOX with rawCAN mode.

When I tried to check the wiring, I run RIOX with miniCAN mode and can see the CAN frames transmitted by RIOX correctly on Peak-View program.
Then I send a can packet to the RIOX and type a '?CF', but as a result I got always CF=0. In this case I set up the listenNode ID as 0.

When I replaced the RIOX with FBL2130 and sent a can packet from Peak-View to the controller, I can get the CF=1.

What is the problem that you guys think?

Thank you.

Please Log in or Create an account to join the conversation.

6 years 1 month ago #29533130 by blake
Replied by blake on topic rawCAN is not working on RIOX
What version of firmware is currently on your RIOX? This will show in the bottom right corner of the RIOX Programming Utility when it is connected. Please share version number and date.

Please Log in or Create an account to join the conversation.

6 years 1 month ago #29533131 by yoo0911
Firmware ID is Roboteq v1.2 RIOX1216AH 03/28/2017

Please Log in or Create an account to join the conversation.

6 years 4 weeks ago #29533134 by niko
Replied by niko on topic rawCAN is not working on RIOX
There were some issues that are now solved. Please send us an e-mail in This email address is being protected from spambots. You need JavaScript enabled to view it. in order to provide you with a beta firmware.

Please Log in or Create an account to join the conversation.

6 years 4 weeks ago #29533137 by yoo0911
This email address is being protected from spambots. You need JavaScript enabled to view it.

Is this email address correct?
I can't send you email with this address.
Could you check one more?

Please Log in or Create an account to join the conversation.

6 years 4 weeks ago - 6 years 4 weeks ago #29533142 by yoo0911
Hi,

I can get the beta firmware and tested. but I have still same problem.
Is this only one case?

I attached the file that you can see my setting parameters for can bus on RIOX.
Attachments:

Please Log in or Create an account to join the conversation.

Time to create page: 0.080 seconds