Menu

Topic-icon AX 3500, mistake at the datasheet???

More
10 years 2 months ago #29525123 by ron2468
Hi all,

I\'m trying to connect an optical encoder to the roboteq ax3500. At page 134 there is a table that shows how to connect the encoder to the controller. The encoder I\'m using is USDIGITAL OPTICAL ENCODER E5.

My problem is in the conection table at P134. Where to conncet Encoder1 channel A ??? maybe there is a mistake at line 6?

anyone???

Thanks!!!

Please Log in or Create an account to join the conversation.

  • cosma
  • cosma's Avatar
10 years 2 months ago #29525126 by cosma
Replied by cosma on topic AX 3500, mistake at the datasheet???
Make sure you are using the user manual v19b

Pinout is:

1 Encoder 2 - Channel B
2 Encoder 2 - Channel A
3 Ground (same as pin 7)
4 5V Out (same as pin 8)
5 Encoder 1 - Channel B
6 Encoder 1 - Channel A
7 Ground (same as pin 3)
8 5V Out (same as pin 4)

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.133 seconds
Go to top