I am trying to set DOUT1 and/or DOUT2 to high level (I am going to use them for brake coils, but now they are disconnected). I measure voltage between pins 1/5, and 9/14, but it\'s always 0.
I tried different modes for Digital Outputs in the Configuration tab. Like \"Motor is On\", etc. I see that DOut1 and DOut2 icons/buttons in the Run tab do change to active appropriately (or I change them manually), but the output voltage on the pins is always 0.
Voltage between 13/14 is 5V as it should be.
Motors\' PWM Signals work fine.
The motor controller is new, nothing bad happened to it, so it should be working.
What can the problem be about? How to trouble shoot it?