Roborun+ does not recognize SDC2150 connected via USB

7 years 9 months ago #29527657 by mrienks
Hello,

I am trying to connect to my SDC2150 via USB, but without success. Roborun+ says: Found COM3 - COM3 is closed. Is there anything which needs to be configured at the PC side?

Thanx for your help.

Maurice

Please Log in or Create an account to join the conversation.

7 years 9 months ago #29527659 by roboteq
You do not need to do anything special.

verify that when you unplug the controller, COM3 disapears.

if it disapears, that would mean that the controller driver correctly loaded and that it should be able to communicate with the PC utility

if COM3 is still present, then this means that the controller never was found by the PC and that there may be a problem with the controller, cable or PC

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.102 seconds