Magnetic Guide Sensors_Continuous disconnecting via serial communication

3 years 2 months ago #29533040 by Gunasekara
Hi
wrote a code for the sensor and uploaded to it.After that it doesn't connect to the PC.
Is there way to reset(erase) the code that i uploaded.

code-

dim select_right as boolean
top:
setcommand(_DSET,TV)
setcommand(_DRES,TX)
goto top

thank you

Please Log in or Create an account to join the conversation.

3 years 2 months ago #29533041 by roboteq
you need to connect to the PC with serial port. Then select the com port manually on the utility. Then keep pressing on the pause script button.

Please Log in or Create an account to join the conversation.

3 years 2 months ago - 3 years 2 months ago #29533048 by Gunasekara
I mentioned about the magSensor control utility .It does not include the pause button.
Thank you.
Attachments:

Please Log in or Create an account to join the conversation.

3 years 2 months ago #29533058 by blake
Attachments:

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.213 seconds