RC to RS232 switch

15 years 5 months ago #2780988 by slaudato
RC to RS232 switch was created by slaudato
I am attempting to set up a autonomous system with RC control as an emergency back up. I have figured out how to switch from RS232 mode to RC control
>^00 01
>%rrrrrr
I then see the expected ASCII output string updating the status of the parameter set, but I can not get my AX2550 to respond to either a new command mode, or the ten return carriages to reset the controller to RS232 mode from RC.
Ideally I would like to have a default setting of either RC or RS232, then switch to the other when desired, and then reset the controller to return to the default setting. Is there a way to do this?

Please Log in or Create an account to join the conversation.

15 years 5 months ago #2783619 by cosma
Replied by cosma on topic Re:RC to RS232 switch
See the application note at <A href=" dev.roboteq.com/dev1/download/RS232-RCSwitchoperation.pdf " target=_blank target=_blank> dev.roboteq.com/dev1/download/RS232-RCSwitchoperation.pdf </A>

See also the other discussion thread re: RS232 to RC.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.092 seconds