Menu

Topic-icon Digital out puts behaving weirdly

More
4 years 8 months ago #29530405 by Hannari
Can anyone explain why the Dout 1 is low and Dout 2 is high when I have both set to the same config., both are set to Active High and Activate Never.
Attachments:

Please Log in or Create an account to join the conversation.

More
4 years 8 months ago #29530409 by TechSupport
You can manually activate the digital outputs in the run tab by clicking on the led light in the digital outputs.

The active high and when never is normal for at least eh MDC2xxx controllers. Most of the others are preset to atcive when motor 1 is on and output 2 when no mos fail.

Having it set to active when "Never" means that you can manually enable this output,rather than having a condition turn the output on.

Please Log in or Create an account to join the conversation.

More
4 years 8 months ago #29530413 by Hannari
Oh… I get it, I must have pushed one of the digital outputs.
Thanks a lot for the help.

Please Log in or Create an account to join the conversation.

More
4 years 8 months ago - 4 years 8 months ago #29530414 by TechSupport
The digital outputs are the only ones you can toggle on and off using the led lights. All others either require a configuration change to set active low, or to input a voltage signal on the input to turn them active on.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.100 seconds
Go to top