Menu

Topic-icon AX3500 Motor Controller Serial Connection Failure

More
1 year 8 months ago #29533566 by rwbot
Aloha!

I’m from Jamaica/Hawaii and studying as an electrical engineering sophomore at Trinity college, Hartford, Connecticut, USA. I'm using the Roboteq AX3500 Motor controller to build an autonomous vehicle for the IGVC competition. All the parts (including motor controller and motors) are from the teams of previous years. There was no documentation left over, so I had to figure out how to use it from scratch.

I followed the quick start guide and successfully ran the Self Test, where the motors were separately engaged frontwards and backwards until shut off.

I’m now trying to connect it to a PC running Windows 7 to use the Roborun software, but nothing happens. In Roborun, when I leave the port selection on Auto, it cycles through “COM1 closed, COM3 closed” over and over and says Disconnected. When I manually select COM3, it says Connected, but nothing changes.
I’ve attached a log from the session. In the console, I just get stuff like:
??\x04
?”?
\x12A
E?
*

File Attachment:

File Name: AX3500_LOG...4-05.txt
File Size:1 KB


Since the Self Check verifies the motor is capable of running correctly, I’m assuming the problem lies in the RS232 cable. The cable I’m currently using was modified by previous teams. Following the manual, which said only Pins 2, 3 and 5 were needed for basic communication, I disconnected all the wires on both the male and female, except those in pins 2, 3 and 5, and insulated the disconnected with electrical tape.

I’m not sure what to do from here, so any help will be appreciated!

Contact:
This email address is being protected from spambots. You need JavaScript enabled to view it.
(860) 994-2072
Attachments:

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.088 seconds
Go to top