Menu

Topic-icon 3550 Encoder problems

  • ron
  • ron's Avatar Topic Author
14 years 8 months ago #4722868 by ron
3550 Encoder problems was created by ron
<P style="MARGIN: 0px">We have triple checked the wiring to the two encoder modules from the 3550 yet we get 5v on encoder 1 channel B, and .08v where 5v is supposed to be.
<P style="MARGIN: 0px">
<P style="MARGIN: 0px">we are using USD encoder modules
<P style="MARGIN: 0px">

Please Log in or Create an account to join the conversation.

  • cosma
  • cosma's Avatar
14 years 8 months ago #4723277 by cosma
Replied by cosma on topic 3550 Encoder problems

The published pinout in the manual is correct. If you want to be sure, you may probe the 8 metal wires that are on top of the RJ45 connector. The wire that is the closest from the 15-pin connector is pin 1. If you find the +5V and ground at the right place on the connector, but not on the encoder, the wiring may be wrong or there may be a bad connection inside the connector

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.084 seconds
Go to top