Menu

Topic-icon AX500 position-at-speed control

More
9 years 6 months ago #29525180 by Stefanw
I am using an AX500 in analog-feedback position control mode.

It would be nice if there were a \'position at speed\' command (or speed limit configuration option) - so instead of saying \'go to this angle at maximum speed\' I could say \'go to this angle at a speed not exceeding 10 degrees per second\'

At present I have a robot arm with potentiometers on its joints; however, the motors powering it are faster than we expected, so under certain circumstances the arm moves very fast to a target position.

I am aware that I can reduce the PID gain and the current limits to reduce the power to the motors. The problem is, depending on the arm\'s position, a given amount of power can produce a different speed - for example, if I limit the power to go at a reasonable speed when the arm is descending under load, it doesn\'t have enough power to ascend under the same load!

Thanks.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.089 seconds
Go to top