Menu

Topic-icon Suggestion: MDC2230 3D model

More
2 years 7 months ago #29532760 by Brogath
Hello Roboteq,

Just yet I downloaded the 3D model for the MDC2230 and noticed that the encoder connector drawn inot the model is only 5 pins instead of 6 pins.

We use a software package that draws each individual cable so a missing pin can be a problem if it goes unnoticed.

While it is no big deal, I figured it would not hurt to let you know about it.

and even though the connections on the back are all present, the distance between them seems a bit off too, but I doubt this detail would ever cause a problem, even for automated routing/cabling
The following user(s) said Thank You: blake

Please Log in or Create an account to join the conversation.

More
2 years 7 months ago #29532765 by blake
Replied by blake on topic Suggestion: MDC2230 3D model
Thank you very much for bringing this to our attention

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.084 seconds
Go to top