Menu

Topic-icon RS-485 modbus enable

More
10 months 1 week ago #29534351 by zest8x
RS-485 modbus enable was created by zest8x
I would like to enable modbus-rtu by enabling RS-485 communication of "SBL2360".
I tried the wiring according to the manual but there is no response.
And what does the meaning of the "^ DMOD 0" command mean to use modbus-rtu?
Can USB communication and rs-485 be used at the same time?

Please Log in or Create an account to join the conversation.

More
9 months 1 week ago #29534438 by Gabriel_Isko
Replied by Gabriel_Isko on topic RS-485 modbus enable
Hey, Sorry I missed this post. We do not support modbus RTU on our controllers, only Modbus ASCII. The controller cannot mirror the ports, but it should be able to use them both concurrently.

I am actually not sure what DMOD does, and I will have to consult with our firmware engineer. I will let you know if I get an update.

Please Log in or Create an account to join the conversation.

More
7 months 3 weeks ago #29534543 by zest8x
Replied by zest8x on topic RS-485 modbus enable
Is modbus-RTU applied in roborun v2.0?
I have read the updated document.

When will it be released?
Which products will be applied?

Please Log in or Create an account to join the conversation.

More
7 months 2 weeks ago #29534556 by Gabriel_Isko
Replied by Gabriel_Isko on topic RS-485 modbus enable
I am pretty sure we do not support any form of Modbus RTU, no matter which firmware.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.085 seconds
Go to top