Menu

Topic-icon How to use the close loop speed position mode

More
1 week 6 days ago #29534627 by Easy

Hi everyone,
I am using SBL1360 to control a brushless motor. I am trying to control the speed and position at the same time to let it track a predefined trajectory, so I think the close loop speed position control mode is the most suitable mode I can use. I successfully set up the encoder reading and it is very accurate. However, I do not know how to use the speed positon mode. Since I have a predefined trajectory, should I use a series of go to speed command, or is there any other ways to provide the input? Thank you very much!

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.061 seconds
Go to top