Menu

Topic-icon connecting roboteq to radio control systemes

More
3 months 2 weeks ago #29533473 by senda

Hello,

In my robot , i use to roboteq to control my 2 motors. I want to know if i can install th receiver of radio control spectrum DX5C with two roboteq and how can i connect them.

thank you and my best resgrds,

Please Log in or Create an account to join the conversation.

More
3 months 2 weeks ago #29533474 by Gabriel_Isko

You did not mention which receiver you are using. However, if it provides 3 pin output on each of its channels, you should look at the CABLE-RC items in the Cables and Acessories section of our webstore. We have one with a 15 pin Dsub connector, and one with a 25 pin Dsub connector - the proper one for your application will depend on your motor controller.

To connect and configure the inputs on our motor controller, please refer to page 53 as well as SECTION 4: I/O Configuration and Operation of our User Manual .

Please Log in or Create an account to join the conversation.

More
3 months 1 week ago #29533478 by senda

The recever that i will use it is SR415, and yes it provides 3 pin so can i connect it with my two roboteq ?

Please Log in or Create an account to join the conversation.

More
3 months 1 week ago - 3 months 1 week ago #29533484 by Gabriel_Isko

It should work with one of our pulse inputs. You can find the adapter cables I was talking about here , under the Cables and Accessories tab.

Please Log in or Create an account to join the conversation.

More
3 months 6 days ago #29533493 by senda

In fact i have 4 motors , each two motors are contolled by SBL23, and i will use DX5C DSMR 5 CH TX w/SR415 so my question is how can i connect my receiver with my two roboteq .

Please Log in or Create an account to join the conversation.

More
3 months 6 days ago #29533495 by Gabriel_Isko

For the SBL2360, you can use the cable found here .

All you will have to do is configure the control in Roborun+ to use a pulse input to send motor commands to your controller. For a complete reference please reference Section 4 of our User Manual (The section I referenced in my previous post).

If you are trying to use 2 controllers to implement a single drive system, I would recommend trying to use our roboCAN networking features. Please see section 16 of our User Manual

Please Log in or Create an account to join the conversation.

Moderators: opal
Time to create page: 0.074 seconds
Go to top