Menu

Topic-icon Microbasic Transfer

More
4 years 8 months ago #29529588 by karman

Hi,

Seeing the PC utility is not working is there any other way to transfer Microbasic Code to the Rio ?

Thanks
L:

Please Log in or Create an account to join the conversation.

  • Griffin Baker
  • Griffin Baker's Avatar
4 years 7 months ago #29529590 by Griffin Baker

Which one did you use?

Please Log in or Create an account to join the conversation.

More
4 years 7 months ago #29529594 by karman

Rev 1.2 1/4/14
all is fine until you click on scripting tab then just says, sensor lost and below in the log screen

only way to get things going again it to power of the rio and power on again. No even minicom gets response

!r 0
+
# C
?trn
TRN=RCB100M:RIOAHRS
?FID
FID=Roboteq v1.3 RIOAHRS 03/17/2014
# C
|~
|~=EE:0:3

Please Log in or Create an account to join the conversation.

More
4 years 7 months ago #29529604 by karman

Bump

Please Log in or Create an account to join the conversation.

More
4 years 7 months ago #29529605 by mygoggie

karman wrote:

Rev 1.2 1/4/14
all is fine until you click on scripting tab then just says, sensor lost and below in the log screen

only way to get things going again it to power of the rio and power on again. No even minicom gets response
!r 0
+
# C
?trn
TRN=RCB100M:RIOAHRS
?FID
FID=Roboteq v1.3 RIOAHRS 03/17/2014
# C
|~
|~=EE:0:3

Please sort this problem out as our development program is now standing as we cannot upload the Microbasic code. OS = Windows 7 and Raspberry has latest firmware installed. We have tried with other RPIs as well with the same issue.

Please Log in or Create an account to join the conversation.

  • roboteq
  • roboteq's Avatar
4 years 7 months ago #29529606 by roboteq

Are you connected to the rio via USB or Serial?

If USB, try makeing a cable and use serial. Serial is always more robust.

When clicking on the script tab, the utility asks RIO to dump the list of all supported commands and queries.

It sends |?, |!, and |~. Try to send these from the console and see which cause the controller loss and where.

We will also do some testing on our side.

Please Log in or Create an account to join the conversation.

More
4 years 7 months ago #29529607 by karman

From the Raspberry using riocom:

|? => B:0:5

Then no more response

Unable to make up RS232 cable as I don't have the components or time.

L:

Please Log in or Create an account to join the conversation.

More
4 years 7 months ago #29529608 by karman

|!=B:0 .. Then no response

Please Log in or Create an account to join the conversation.

More
4 years 7 months ago #29529609 by karman

|~=EE:0:3 => no response

so basicly all of them cause rio to hang

Please Log in or Create an account to join the conversation.

  • roboteq
  • roboteq's Avatar
4 years 7 months ago #29529610 by roboteq

We can see the problem. We'll address.

Please Log in or Create an account to join the conversation.

Moderators: opal
Time to create page: 0.098 seconds
Go to top